DREW ELECTRIC 2000 (Motor and Parts Cleaner)

DREW ELECTRIC 2000 (Motor and Parts Cleaner)

德鲁马达及电器清洁剂

4064408

Packaging：25L/Tub

PCN: 4064408

Description

DREW ELECTRIC 2000 motor and parts cleaner is a highly efficient, non-chlorinated solvent designed to be used in electric parts cleaning applications requiring deep penetration with a controlled evaporation rate. It is economical to use and can be applied on large motors, generators, and electrical apparatus, as well as smaller equipment. DREW ELECTRIC 2000 cleaner has a high dielectric strength and low non-volatile residue value making it an excellent replacement for 1-1-1 TCE-based products.

Application and Use

DREW ELECTRIC 2000 cleaner may be used in dip, wipe or spray cleaning applications. The product is used full strength. A few minutes soaking is usually sufficient to loosen and disperse most oily deposits. For severely soiled parts or windings, DREW ELECTRIC 2000 cleaner may be allowed to soak into the deposits for up to two hours. The container should be covered with a lid to control evaporation and minimize dangerous vapors. Use of a water seal is not recommended to prevent evaporation. Upon completion of cleaning, generator and motor windings should be blown clear with clean, dry compressed air, then followed by warm air blowers for drying. Small parts may be blown clear or rinsed with clean water, then air dried after soaking or wiping with DREW ELECTRIC 2000 cleaner.

It is our recommendation that when cleaning with this product, all equipment should be off-line and discharged.

CAUTION: DREW ELECTRIC 2000 cleaner must be used with adequate ventilation. Keep container covered.

Typical Physical Properties

Appearance: Clear, pale yellow liquid

Specific Gravity at 25° C (77° F): 0.82

Flash Point (PMCC): 93° C (200° F)

Stability: Stable after repeated freeze/thaw cycles

Packaging

DREW ELECTRIC 2000 motor and parts cleaner is available in 25-liter containers.